Ho Scale layout , New Planning ... start over again...

 First off all , sorrry forr the mess in the photos !
I had an idea to stop the previous layout and start over again . The main reason  was  that  I bought  the LENZ LZV100 and started plans   for computer control .

 I chose the  Roco geoline  rail series . They needed much modification in order to make  the rails  tighter to each other . After some test I found the way to do it  by removing some part (around 2cm) from the thrown position of every switch).
I also added  in the eend of each shelf square retractable shelves of 80x80cm  where I put R2 curves  in order to be able to have full rail trip  and also   not to have space problems in my workshop.

 Here is the shelf retracted

 Here you may see the  Octopus II switch manager  with Octocoder decoder . Also  , on the far left, you may see the LR101 which generates the feedback for the sensors.

 A full view of the mess....

 Below view with some initial wiring. I plan to change everything  and add notes on each wire .

 Here , I installed the laptop for the computer contol

 A more close view of  the devices described above.

 I have not yet found out the final  rail plan . Due to heavy modification  of the Roco Geoline  rails  , I was not able to make a plan in Anyrail  and then make it on the board .

 Here is the first , left , turn(loop)

 Here  is the right  turn (loop) . The  plan is finally closed.

 Here you may see the right loop retracted in order to  give me access to the entrance.. !

 Loop , bridge and shelf connected.

 Some tests arround . Nothing is final . All rails are not permanently fixed so if anythign goes wrong I can make changes..

 A more dramatic view of the Wehrmacht Loco .

 Here is a more updated  view of the layout shelves below.

To be updated very soon....